If you know why this happens pls help. model Ender 3.
this post was submitted on 26 Sep 2026
22 points (100.0% liked)
3DPrinting
24237 readers
90 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: or !functionalprint@fedia.io
There are CAD communities available at: !cad@lemmy.world or !freecad@lemmy.ml
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 3 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
So for me the big bad indicator is basically the upper right corner on the one hand it looks like it was squished to much on the other it looks like an adhesive issue on the last layers of the right side.So a few questions that pop up for me: How does the file look like? Is it maybe wrongly sliced and the last part is in the air? Did you do manual mesh bed leveling? Did you check the bed level from the gantry to the plate with a kaliper to make sure it doesn't change height between prints (to much)? How old is you nozzle? Is it maybe partially blown?
I immediately noticed the floating extrusion. but when you said this i realized they where right next to each other. if thats a bad sensor the manual leveling might work but i wonder if theres something(probably a bit of filament waste) under the sheet causing it to ripple or the build plate isnt very flat.
a high spot during probing could cause havoc on the interpolation and i could see it causing something like this. manual leveling would kinda help that but that spot would still be a disaster.
Yeah it's a weird thing that I would assume cones from bad slicing, a bad bed or bad mesh leveling. But this can have different reasons too.
Further there are holes in the print, which are a possible problem with extrusion width
Edit: it could also be that it was a bed level change mid print notice how some of it is printed over.
Sorry I had an emergency and was away. My bed level wasnt good I think. I did some leveling and all again now the prints are fine. Yet still minor (negligible) issues with the print. My nozzle may be not that good now. Its old. But since the prints are fine now so Im using It.
Yeah not a problem. If I don't get an answer than I just assume it's solved
Thanks for the support. My bad to respond late. Thanks.