I've posted previously to the saga, and I have some updates. My prints are getting better, but still have room to grow. Thus far I have:
- Updated my printer's firmware from 2019 -> 2023 (latest) because pause commands (G4) was not being respected. That was an ordeal since it's only supported to be done on windows/mac...I nearly bricked it doing it on linux, then spun up a windows VM and got it done. Took 3 days.
- Changed the orientation of the prints so the stem points down.
- Lifted the print so everything prints on supports, about 1/16 inch
It's looking MUCH better, but I'm having a stringing issue which is preventing the keycap from installing. I think this is a much easier fix, and I have knobs to turn on this:
This, everything else printed except the clicker/eraser:
https://www.thingiverse.com/thing:7193780
Edit: I have a folder of about 100 keycap models, so I've been jumping around.